Test the new garage door remote by pressing once to see if the door moves.
How to program remote garage door opener.
To program a new remote into the system hold the learn button until the indicator light blinks on the opener.
Select remote to program from the program menu.
Press and release the learn button on the garage door opener or door control.
Steps to program a garage door opener step 1.
Press and hold the button for about fifteen seconds until the light on the opener blinks.
How to program a different remote garage door opener.
To exit programming press and release any remote control button except the button that was just programmed.
This indicates that the door opener is ready to be programmed.
After pressing the program button on the opener you ll have approximately 30 seconds to get to your remote and press the button.
Locate the learn button.
Depress and hold the learn or set button located near the short wire antenna until.
Next you need to find where the learn button is on your system.
Use the navigation buttons to scroll to program.
Access the garage door opener motor housing.
This can vary from.
While the indicator light is blinking press the button on your remote.
The short remote control wire antenna and.
This video is for liftmaster chamberla.
Press the button on the remote control that you wish to operation your garage door.
Step 3 program the remote.
Remove the plastic light lens cover if applicable.